HOME  »  Andre's 1968 Triumph GT6 MK1 - 2008 Photo Gallery » 05 Apr 2008 SU 1.75" Install Part 1  (11 Slides)     [Page 1 of 1] :: Jump To  
  Up one level  
DSCN3423 * So it was warm, I had some free time. * So it was warm, I had some free time. * 2288 x 1712 * (1.4MB)
DSCN3424 * I've not altered the manifold, but used the TT plates. * I've not altered the manifold, but used the TT plates. * 2288 x 1712 * (1.21MB)
DSCN3425 * The front carb, I had to use studs to mount. Bolts were not going to fit. * The front carb, I had to use studs to mount. Bolts were not going to fit. * 2288 x 1712 * (1.23MB)
DSCN3426 * I had to grind the throttle shaft down a touch, it was too wide. * I had to grind the throttle shaft down a touch, it was too wide. * 2288 x 1712 * (1.38MB)
DSCN3427 * Bolt on the back carb. * Bolt on the back carb. * 2288 x 1712 * (1.39MB)
  DSCN3423  
  DSCN3424  
  DSCN3425  
  DSCN3426  
  DSCN3427  
DSCN3429 * Stud with 2 nuts, I will have to install a lock washer on the back piece. * Stud with 2 nuts, I will have to install a lock washer on the back piece. * 2288 x 1712 * (1.3MB)
DSCN3430 * 2288 x 1712 * (1.28MB)
DSCN3431 * Filter gasket. * Filter gasket. * 2288 x 1712 * (1.4MB)
DSCN3432 * I dont think my K&N's will not fit. * I dont think my K&N's will not fit. * 2288 x 1712 * (1.33MB)
DSCN3433 * 2288 x 1712 * (1.31MB)
  DSCN3429  
  DSCN3430  
  DSCN3431  
  DSCN3432  
  DSCN3433  
DSCN3434 * 2288 x 1712 * (1.32MB)
  DSCN3434  
Album last updated on Mar 06, 2009 - 04:39 PM
Powered by Jalbum 8.2 and BluPlusPlus skin
GT6.ca